V880 Pci Card Configuration - Avaya Sun Fire V880 Installation & Maintenance

Maintenance

V880 PCI card configuration

The cards are installed in the slots shown in the following table. The minimum configuration has
either a SunSwift card or a Dual FastEthernet and Dual SCSI card in Slot 2 and the graphics
card in slot 7.
!
Important:
On earlier versions of the V880, the ethernet cards were installed in the following
Important:
order:
Avaya now recommends that ethernet cards be installed as shown in the following
table:
Slot
Number Type
8 33/66MHz, 3.3V
7 33/66MHz, 3.3V
6 33MHz, 5V
5 33MHz, 5V
4 33MHz, 5V
3 33MHz, 5V
2 33MHz, 5V
1 33MHz, 5V
0 33MHz, 5V
1. Hot-plug operation for a PCI card requires that the card have detach-safe drivers. If the card does not have
detach-safe drivers, the system must be shut down to add, remove, or replace the card.
2. The computer supports a maximum of four ethernet cards. The optional ethernet cards can be the FastEthernet,
Quad GigaSwift, and single Gigabit ethernet cards.
3. The computer supports a maximum of two HSI/P cards. The first card must be in Slot 3. CMS R12 and later does not
support HSI/P cards and X.25.
4. Some models of the SCSI cards support hot-plug operation, but Avaya recommends that you replace those cards
while the system is powered down.
62
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Slots 0, 1, 2, and 5
Reserved for future use
Graphics (required)
Third ethernet card
Fourth ethernet card
Second HSI/P
3
First HSI/P
SunSwift (required), or
Dual FastEthernet and Dual SCSI (required)
Second ethernet card
Empty
Card
Name
2
(optional)
2
(optional)
3
(optional)
(optional)
2
(optional)
Supports Device
1
hot-plug? type
N/A N/A
No N/A
Yes ce
Yes ce
No N/A
No N/A
4
No ce
4
No ce
Yes ce
N/A N/A
May 2006