Installing A Cpu/Memory Board - Avaya Sun Fire V880 Installation & Maintenance

Maintenance
8. Holding the bottom edge of the module parallel to the socket, align the module so that
each of the contacts is centered on a socket pin. See the following figure.
9. Push firmly and evenly on both ends of the memory module until the bottom edge is firmly
seated in the socket. You will hear a click when the ejection levers are in the locked
position.
10. Replace the plastic cover on the CPU/Memory board.
11. Continue with

Installing a CPU/Memory board

Use this procedure to install a new CPU/Memory board or to reinstall a CPU/Memory board that
was removed for maintenance.
To install a CPU/Memory board:
1. If not already done, open the right door.
2. If not already done, attach one end of an ESD antistatic wrist strap to the system chassis
sheet metal and attach the other end to your wrist. See
page 59 for more information.
3. Locate the CPU/Memory board slot into which you want to install the CPU/Memory board.
4. If a CPU/Memory board connector yellow dust cover is installed on the slot's motherboard
CPU/Memory board connectors, remove it.
140
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Installing a CPU/Memory board on page 140.
Using an ESD wrist strap on
May 2006