Installing Hsi/P Software And Patches; Setting Up The Switch Link For Each Acd - Avaya Sun Fire V880 Installation & Maintenance

24. Enter:
boot -r
This reboots the system so that it recognizes the new HSI/P cards.
Note:
Sometimes the system fails to recognize a newly installed HSI card. If this
Note:
happens, the command show-devs does not show the HSI card and /var/
adm/messages fails to recognize the card upon bootup. See the troubleshooting
chapter of Avaya Call Management System Switch Connections, Administration,
and Troubleshooting for information about troubleshooting HSI/P cards.
25. When the system comes back up, log in as root.
26. Enter:
cfgadm
This displays the PCI card configuration after you add the card. Make sure that the new
card is displayed.
27. Continue with

Installing HSI/P software and patches

Use the following procedures in the CMS software installation, maintenance, and
troubleshooting document to:
Install the HSI/P software
●
Reinstall the Solaris patches
●
After installing the software and patches, continue with
ACD on page 91

Setting up the switch link for each ACD

To change the switch link administration for each ACD:
1. Enter:
cmssvc
The CMS Services menu is displayed.
2. Select the run_cms option.
3. Turn off CMS.
4. Enter:
cmssvc
The CMS Services menu is displayed.
5. Select the swsetup option.
Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting
Installing HSI/P software and patches
Maintaining PCI cards
on page 91.
Setting up the switch link for each
91
May 2006