Polycom SoundStructure C16 Design Manual page 641

Argument Argument value
Virt Chans Mono
continuous : Continuous (default)
1/24 : 1/24 Octave
1/12 : 1/12 Octave
Values
1/6 : 1/6 Octave
1/3 : 1/3 Octave
1 : 1 Octave
Event Source No
Description
When the signal generator's sig_gen_type is set to sweep, this parameter sets
the step size of the sweep generator. This signal generator can sweep continu-
ously, in fractional octave steps, or in full octave steps.
sig_gen_sweep_stop
Argument Argument value
Channel Type Virtual Channel
Value Type Floating-Point
Read/Write Mode Read/Write
Phys Chans Signal Generator
Virt Chans Mono
System Limits Minimum: 20.0, Maximum: 20000.0, Resolution: 0.1
Default 20000.0
User Limits No
Supported
Event Source No
Description
When the signal generator's sig_gen_type is set to sweep, the parameter sets the
frequency (in Hz) at which the sweep generator stops. The direction of the fre-
quency sweep will be up or down depending on whether the
sig_gen_sweep_start parameter is higher or lower than this parameter.
Command Protocol Reference Guide
Signal Generator Sweep Stop Frequency
A - 125