Polycom SoundStructure C16 Design Manual page 325

Name Possible Values
IP Gateway Dotted-decimal IP
address
DNS Server Dotted-decimal IP
address
DNS Alternate Dotted-decimal IP
Server address
DNS Domain Domain name string
Serial Port Enables (default) or
disables
Storm Filtering Enable (default) or
Disable
LAN Port Mode Auto (Default), 10HD,
10FD, 100HD, 100FD,
1000FD
See the Polycom UC Software Administrators Guide 4.0.1 for additional infor-
mation about the advanced settings of Ethernet 802.1x and PAC File Info.
The VLAN settings are described in the following table.
Name Possible Values
VLAN Null, 0 through 4095
VLAN Filtering Enable or Disable
(default).
LLDP Enable (Default) or
Disable.
Description
Enter the IP address of the router that is the address the
SoundStructure VoIP Interface will go to when seeking
IP addresses outside of the local subnet.
Enter the IP address of the primary domain name
server.
Enter the IP address of the secondary domain name
server.
The phone's Domain Name System
If enabled, a debug serial port is active.
If enabled, the DoS storm prevention state ethernet
packet filtering is used to prevent TCP/IP stack
overflows caused by invalid or excessive data.
Choose the speed of the network on the Ethernet
interface.
Description
Enter the DHCP private option value to be used when
VLAN discovery is set to custom
Enables or disables the VLAN ethernet packet filtering
on the phone to prevent TCP/IP stack overflows caused
by invalid or excessive data.
If enabled, the phone will use the LLDP protocol to
communicate with the network switch for certain
network parameters. Most often this will be used to set
the VLAN that the phone should use for voice traffic. It
also reports the power management requirements to
the switch.
The SoundStructure VoIP Interface
12 - 27