Polycom SoundStructure C16 Design Manual page 565

Command
phone_exit_tone_en
Argument
Channel Type
Value Type
Read/Write Mode
Phys Chans
Virt Chans
Default
Event Source
Description
This parameter enables or disables exit tone generation for the telephony inter-
face. If exit tones are enabled (1), then an exit tone is played whenever the
auto-hangup feature engages and disconnects the telephony interface. Entry
tones (see the phone_entry_tone_en parameter) and exit tones are typically
enabled to prevent a caller from entering or exiting a conference unannounced.
phone_flash
Argument
Channel Type
Value Type
Read/Write Mode
Phys Chans
Virt Chans
Event Source
Description
Setting this parameter disconnects the telephony interface then reconnects it
after a short delay. The amount of delay can be configured with the
phone_flash_delay parameter.
Examples
Response
Enable Exit Tones For Telephony Interface
Argument value
Virtual Channel
Boolean
Read/Write
Analog Telephony Input, VoIP Telephony Input
Mono
1
No
Connect Or Disconnect Telephony Interface
Argument value
Virtual Channel
Void
Write-Only
Analog Telephony Output
Mono
No
Description
Command Protocol Reference Guide
A - 49