Polycom SoundStructure C16 Design Manual page 539

Some examples of parameter commands are given below.
get sys_sw_ver 1
set mic_in_gain "DVD Audio" 10
set fader max "DVD Audio" 10
inc fader "DVD Audio" 2
tog aec_en "Mic 1"
set eq_en "Speaker 1" 1
set peq_gain "Speaker 2" 1 -2.5
set matrix_gain "DVD Audio" "Codec Output" 0
The fields in the command are described below.
<action>
This is a required field that specifies the action for the command. The require-
ments for the format of this field are given previously. The action must be one
of the following values:
Action Description
get get the current value of the parameter
set set the current value of the parameter; requires the value as
an argument
inc increment the current value; requires the value to increment
by as an argument
dec decrement the current value; requires the value to
decrement by as an argument tog toggles the state of the
current value; only applicable to Boolean commands
tog toggles the current value of the boolean parameter
ping does not affect any parameter, just checks that the system is
accessible
run runs a preset or partial preset
<param>
This is a system-defined text argument that specifies the name of the parame-
ter on which to operate.
<limit>
Some parameters support user-definable minimum and maximum values. For
these commands, the <limit> argument can be specified. The <limit> argu-
ment is a system-defined text argument and can be one of the following values:
Command Protocol Reference Guide
A - 23