Polycom SoundStructure C16 Design Manual page 375

voip_dhcp_boot_serv_type
voip_dhcp_option_60_type
voip_dial_mode
voip_dnd
voip_eth_settings
voip_eth_vlan_id
voip_factory_reset
voip_forward
voip_hold
voip_join
voip_line
voip_line_label
voip_line_state
voip_local_reset
voip_message_waiting
voip_net_cfg_save
voip_prov_serv_address
voip_prov_serv_password
voip_prov_serv_type
voip_prov_serv_user
The SoundStructure VoIP Interface
When voip_dhcp_boot_serv is set to custom, this
parameter specifies the type of the DHCP option in
which the plug-in card will look for the boot server.
Specifies the format for the vendor identifying
information used with a DHCP server when DHCP
option 60 is enabled.
Selects between number dialing and SIP URL
dialing.
Enables or disables the Do Not Disturb mode on all
lines.
Sets or gets the Ethernet settings for the plug-in
card.
Sets or gets the VLAN ID for the plug-in card. A
value of -1 corresponds to no vlan id.
Resets the plug-in card to its factory state.
Used to forward a call.
Places the current call on hold.
Creates a conference from two calls.
Selects a line. This is similar to pressing a line key
on a desktop phone.
Reports the label for the specified line.
Reports the state for the specified line, e.g.,
registered, not registered, active, conference, hold,
etc.
Resets all the voip parameters that SoundStructure
Studio can set: ring type, auto answer, volume of
the auto answer tone.
Indicates whether voice mail messages from any
registered lines are waiting for the SoundStructure
VoIP Interface
Causes the VoIP network settings to be written to
the flash memory.
Sets the address of the provisioning server for the
VoIP interface.
Sets the password for the provisioning server for
the VoIP interface.
Sets the type of provisioning server for the plug-in
card.
Sets the username for logging into the provisioning
server.
12 - 77