Programming The Control - Siemens SINUMERIK 840D Simodrive 611 digital Startup Manual

Programming the control

6.1 Machine and setting data
Programming
The control is matched to the machine by means of machine and setting data.
Machine data
The machine data (MD) is classified as follows:
S
S
S
S
S
S
Setting data
The setting data (SD) is classified as follows:
S
S
S
Option data
Used to enable options. Option data is supplied with the specific option.
Overview of
The machine and setting data is divided into the following areas:
machine and
Table 6-1
setting data
from 1000 to 1799
from 5000 to 6000
from 9000 to 9999
from 10000 to 18999
from 19000 to 19999
from 20000 to 28999
from 29000 to 29999
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
General machine data
Channel-specific machine data
Axis-specific machine data
Display machine data (machine data for front control panel)
Machine data for feed drive
Machine data for main spindle drive
General setting data
Channel-specific data
Axis-specific setting data
Overview of machine and setting data
Area
Machine data for SIMODRIVE drives
Machine data for the hydraulic module
Display machine data
General machine data
Reserved
Channel-specific machine data
Reserved
6
Designation
6-49
6