Table of Contents
Advertisement
11 Data Back-Up
11.7 Data output
Tool management
data
11.7.5
Outputting the standard system start-up file via V24
Preparing for
standard start-up
Selecting the data
Creating an
.
archive file
11-244
The data for tool management can be found in the Tool management directory
in HMI Advanced.This directory has three subdirectories:
S
Magazine configuration (BEISPIEL_DOKU.INI)
S
Tool management configuration (TT110.WMF,....)
S
Tool management data (WZACCESS.MDB,....)
The PARAMTM.INI file for configuring the displays and access levels is located
in directory Diagnosis\HMI Initialization\...
The data selection for standard system start-up must be defined before a stan-
dard system start-up file can be defined. Press the "Standard start-up" soft key
and define which data (HMI, NC, PLC) should be backed up.
Press the "HMI data selection" vertical soft key. In this display you define which
directories are to be contained in the series start-up file.
Select the data.
Press the "OK" soft key. The screen changes.
Press the "Archive" soft key to start creating the "HMINCPLC.ARC" archive file.
When the "Job finished" message appears, the "HMINCPLC.ARC" in the
Archive directory file can be output via the V24 interface.
Set the V24 interface to PC format.
You can also create and output the areas HMI, PLC, NC separately in the form
of series start-up files. The file name then is as follows:
HMI:
HMI.ARC
NC:
NC.ARC
PLC:
PLC.ARC
Note
The compensation data EEC, QEC, CEC are not contained in the series setup
file. Reason: Every machine has its own compensation data.
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
© Siemens AG 2006 All Rights Reserved
03/2006
Advertisement
Table of Contents
