Standard/Export Variants - Siemens SINUMERIK 840D Simodrive 611 digital Startup Manual

1 General Preparation
1.2

Standard/export variants

Documentation
required
1.2 Standard/export variants
Export permits
required
1-14
You will need the following documentation for starting up the SINUMERIK 840D.
A detailed description of the mechanical and electrical structure of the individual
components can be found in:
1. /BU/ Catalog of automation systems for machine tools
2. /PHD/ Device Manual, NCU Configuration
SINUMERIK 840D
3. /PHC/ Device Manual, CCU Configuration
SINUMERIK 810D
4. /PJU/ Converter Configuration Manual
SIMODRIVE 611 digital
5. /BH/ Device Manual, Operating Components
SINUMERIK 840D/840Di/810D
6. /FB1/ Function Guide for Basic Machine
7. /FBA/ Function Guide for Drive Functions
8. /LIS1/ Lists
9. /PI/PCIN Description
10. /DA/ Diagnostic Instructions
11. /IAM/ HMI Start-up Guide
2 variants of the SINUMERIK 840D/810D can be configured due to the
requirement to obtain approval for certain control functions as listed in the
German export list.
The standard variant (840D/810D) can contain the full range of functions of the
control, but is therefore subject to the requirement to obtain approval.
With the export variant (840DE810DE), certain options are not available.
Current information about the type and scope of the options is contained in
Reference material: /BU/ Catalog of automation systems for machine tools
(This shall not affect any requirement to obtain approval with respect to the
intended usage which may also arise).
The specific version of the control is determined by the system software, which
is thus available in two variants (standard and export). This means that the
requirement to obtain approval for the system software (further information may
be given on the delivery note or invoice) is 'inherited' when it is installed on the
control system. This point should be noted, particularly for conversions/
upgrades of the system software, since this may change the requirement to
obtain export approval for the control.
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
© Siemens AG 2006 All Rights Reserved
03/2006