Table of Contents
Advertisement
11 Data Back-Up
11.10 Installing a replacement hard disk
11-254
Note
The Windows operating system and HMI system software are not installed on
the replacement hard disk.
2. Switch on the PG and insert CD into drive.
3. Switch off and on control and select setup mode (press key 6 if DOS window
appears).
4. Select menu "4: Back-up/Restore"
5. Enter the password
6. Select menu option 1 "Hard disk back-up/restore with ghost"
7. Set the parameters for the Norton Ghost program:
– < 1 > configure ghost parameters:
see above
– <3> Hard disk restore from <path name>, PARALLEL mode
* When you select this menu, a message appears:
You are prompted to check whether a connection has been
established between the control and PG/PC.
The image file is displayed for the control onto which
the restore is to be loaded.
* PG/PC:
Start Norton Ghost in a DOS window or at the DOS level
by entering the command ghost –lps to start the
program.
* HMI:
Acknowledge (Yes) the message window to start the restore.
* HMI:
A Norton Ghost message window appears. This contains:
The transfer progress
The paths used
Information about the amount of data to be transferred
Note
If the data transfer is interrupted during the restore operation, the system on the
hard disk is incomplete. A control boot diskette is therefore needed. This must
contain the MS-DOS 6.X boot and the Norton Ghost software.
– < 4 > Back to previous menu
Return to main menu
8. After a successful restore, the control is automatically rebooted.
Duration:
approx. 15–20 minutes
to generate a compressed disk image = 130 MB of a
540 MB hard disk via LPT.
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
© Siemens AG 2006 All Rights Reserved
03/2006
Advertisement
Table of Contents
