Factory Setting Of The Interfaces - Siemens SINAMICS G120 Operating Instructions Manual

Installing
4.6 Installing Control Unit
4.6.4

Factory setting of the interfaces

Factory interface settings
The factory setting of the interfaces depends on the Control Unit.
Control Units with USS or CANopen interface
The fieldbus interface is not active.
--- No function.
DO x: p073x
Speed setpoint (main setpoint): p1070[0] = 755[0]
Figure 4-19 Factory setting of the CU230P-2 HVAC and CU230P-2 CAN Control Units
Control Units with PROFIBUS or PROFINET interface
The function of the fieldbus interface and digital inputs DI 0, DI 1 depends on DI 3.
86
AO 0: p0771[0] DI x: r0722.x
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
AI 0: r0755[0]
Converter with CU230P-2 Control Units