Commissioning Using A Bop-2 Operator Panel; Starting Basic Commissioning - Siemens SINAMICS G120 Operating Instructions Manual
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
5.3
Commissioning using a BOP-2 operator panel
Plugging on an operator panel
Procedure
To plug an Operator Panel on the Control Unit, proceed as follows:
1. Locate the lower edge of the Operator Panel into the matching recess
of the Control Unit.
2. Press the Operator Panel onto the inverter until you hear the latching
mechanism engage.
You have plugged an operator panel onto the Control Unit.
The operator panel is ready for operation when you connect the inverter to the power supply.
5.3.1
Starting basic commissioning
Carry out basic commissioning
Preconditions
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
5.3 Commissioning using a BOP-2 operator panel
• The power supply is switched on.
• The operator panel displays setpoints and actual values.
Commissioning
119
Advertisement
Table of Contents
