Siemens SINAMICS G120 Operating Instructions Manual page 81
Low voltage converters, chassis and wall/panel mounted devices with cu230p-2 control units
Hide thumbs
Also See for SINAMICS G120:
- List manual (1256 pages) ,
- Manual (732 pages) ,
- Operating instructions manual (550 pages)
Table of Contents
Advertisement
Installing a Control Unit in an IP55 Power Module FSD ... FSF
Procedure
Proceed as follows to install a Control Unit in a IP55 Power
Module FSD ... FSF:
1. Open the Power Module door using the key supplied.
2. Locate the lugs at the rear of the Control Unit in the
matching recesses of the Power Module.
3. Mount the Control Unit onto the Power Module so that it
audibly snaps into place.
4. Insert the connecting cable between the Control Unit and
Operator Panel into the Control Unit.
5.
6.
7.
8.
You have installed a Control Unit in an IP55 Power Module FSD ... FSF.
To remove the Control Unit from the Power Module, with the door open, press the release
lever located directly above the Control Unit.
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
Attach the connecting ca-
ble as shown using the
fixing bracket provided.
Wire the Control Unit and
the Power Module.
Check that all of the seals
are undamaged.
Close the cabinet door.
Installing
4.6 Installing Control Unit
81
Advertisement
Table of Contents
