Siemens SINAMICS G120 Operating Instructions Manual page 109

Further information on PROFINET can be found on the Internet using the following links:
– General information about PROFINET can be found at Industrial Communication
– The configuration of the functions is described in the PROFINET system description
This manual describes the control of the inverter using primary control. How to access the
inverter as an Ethernet station is described in the Fieldbus function manual (Page 451) in the
section "The inverter as an Ethernet station".
What do you need for communication via PROFINET?
Check the communication settings using the following table. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the inverter via
the fieldbus.
Questions
Is the inverter correctly connected to
the bus network?
Do the IP address and device name
in the inverter and controller match?
Is the same telegram set in the in-
verter as in the higher-level control-
ler?
Are the signals that the inverter and
the controller exchange via
PROFINET correctly interconnected?
Converter with CU230P-2 Control Units
Operating Instructions, 04/2015, FW V4.7 SP3, A5E34257946B AB
(http://www.automation.siemens.com/mcms/automation/en/industrial-
communications/profinet/Pages/Default.aspx).
(http://support.automation.siemens.com/WW/view/en/19292127) manual.
Answer/description
See: Integrating inverters into
PROFINET (Page 110)
See Configuring communication
to the control (Page 110)
Setting the telegram in the con-
trol
Interconnection in the inverter in
conformance with PROFIdrive,
see: Control via PROFIBUS or
PROFINET with the PROFIdrive
profile (Page 173)
Installing
4.6 Installing Control Unit
Example
Refer to manuals for your
inverter, fieldbus function
manual (Page 451)
109