Ipress - Ryobi 3302H Operation Manual

Chapter 1 Operation Procedures
IPress.•without $erT1IautornatidPiateChangerl
5. Mounting the Plate (Metal Plate)
• Plate cylinder pre-
determined position
stop function
When pushing the
forward crawl button
on each crawl operat-
ion panel with the
drive lamp lighted, the
cylinders will rotate
and stop auto-
matically at the
position where it is
easy to mount the
plate.
( • Introduction
Edition - 19)
1) Mount the plate (metal plate).
_I::::=::::====(1)=
Bend the plate tail edge.
Return the leading edge of the plate clamp to the
standard position (vertical direction). Loosen the
plate tensioning bolt (2) until the stopper (1) contacts
the plate cylinder.
(Operation side, Non operation side)
Return the tail edge of the plate clamp to the standard
position (lateral position). Tum the bolt (2) so that
the edge of the plate clamp is aligned with the third
line (1) from the left edge of the scale on the plate
cylinder.
Set the plate clamp tension switchover lever (1) at
the
D
position.
Operation Edition - 13