Ryobi 3302H Operation Manual page 193

Chapter 3 Periodic Maintenance
c. Manually oiling and greasing each section
A
WARNING
1. Turn OFF the power before lubricating.
2. Mount the cover removed in place after lubrication.
Failure to follow these instructions may result in a serious injury.
All of the required lubrication points are marked with red paint. Use oil
or grease depending on the function of the part.
Lubricate the press following the lubrication chart that is included with
the press.
[Recommended lubrication list for the manual lubrication]
«NOTICE»
1. Use the recommended oil and grease. Do not use the used oil or oil with special additives.
2. The specific gravity and viscosity of the manual lubrication oil is higher than that of the oil for the centralized oiling
system and pump. When this oil is used for the centralized oiling system and pump, the oil circulation may be poor
and then this may cause the trouble with the centralized oiling system and pump.
Maker
Oil
Grease
ALVANIAGREASEEP 1
Shell
GCOILSE100
ALVANIAGREASE 1
Mobil
Mobil DTE Oil Heavy MobiluxEP 1
ESSO
SPARTAN EP 100
LITHTAN 1
TERESSO 100
(Note) 1. The recommended oil is equivalent to anti wear type ISO (International Organization for Standardization)
VG 100.
2. The recommended grease is equivalent to the multipurpose grease (Li) NLGI No.
1.
3. Supply oil and grease at all the lubricating points every week for 3 months after installation. After that,
lubricate the press following the lubrication chart.
Maintenance Edition - 27