Replacing The Sheet Separator - Ryobi 3302H Operation Manual

Chapter 4 Replacing the Supplies
2. Replacing the Sheet Separator
A
CAUTION
Stop the press before replacing. Failure to follow this instruction may result in an injury.
1) Removing
2) Mounting
Maintenance Edition - 40
When the edge of the sheet separator is bent, replace it with a new one.
Loosen the screw and remove the sheet separator.
Mount the new sheet separator and set the separator so that it is positioned
5 mm (0.197'') out from the front surface of the sheet separator bracket
and is 6 mm (0.236") above from the bottom of the notch in the sheet
separator bracket.
(Reference) The standard line for positioning the sheet separator is
marked on the sheet separator bracket. So when mounting
the sheet separator, aligning it with this line assures that it is
mounted at the standard position.
Align the height of the sheet separator to these.
Align with the bent part of
the sheet separator.
I
Sheet separator bracket