Paper Feed Section - Ryobi 3302H Operation Manual

2-7 Paper Feed Section
1) Feeder pile
H
A. Paper feed table
Pile the paper on this table.
B. Vertical guide
When piling the paper, pile it straight following this
guide.
C. Vertical guide handle
This handle is used to set the vertical guides at both
sides of the pile.
~
direction ... The vertical guide will move toward
the pile.
~ direction ... The vertical guide will move away
from the pile.
D. Back guide
This guide is used to guide the back of the paper
pile.
E. F. Side guide
This guide is used to guide the side of the paper pile.
G. Side guide micro adjustment knob
This knob is used to make micro adjustments of the
lateral position of the paper pile.
When turning the knob in
the~
direction, the side
guide moves toward the operation side. The
maximum movement is 5 mm (0.2") and when
turning the knob one complete tum, the side guide
will move 1.3 mm (0.05").
Chapter 2 Names and Functions
H. Paper feed table crank handle
This handle is used to raise or lower the paper feed
table.
[!!]
direction . . . The paper feed table will be raised.
[!]direction ... The paper feed table will be
lowered.
I. Release lever ..
~
position ... While the press is running, the paper
feed table will be raised auto-
matically.
~position
... Stops the paper feed table automatic
elevation. To manually lower the
paper feed table, set the release lever
at this position and tum the crank
handle.
J.
Height control knob
This knob is used to set the height of the paper pile
during the printing.
[!]
direction ... The paper pile height will be raised.
!I]
direction ... The paper pile height will be
lowered.
Introduction Edition - 27