Thin Paper Feeding [Paper With A Thickness Less Than 0.08 Mm (0.0031 ")] (Point) - Ryobi 3302H Operation Manual

Chapter 3 Printing Practice
3-2 Thin Paper Feeding [Paper with a thickness less than 0.08 mm
(0.0031 ")] (Point)
A
CAUTION
Stop the press before setting. Failure to follow this instruction may result in an injury.
1) Adjust the paper pile height.
Pile height
scale
---t~---1
Sheet
separator
bracket
Adjust the paper pile height for the thin paper.
2) Set the suction feet and control the vacuum.
Please do not use the rubber suckers on the suction feet.
Set the vacuum to be as weak as possible.
(Note) If the rubber suckers or strong vacuum is used, the paper will be
squeezed by the suction feet and will not be fed straight up to the
pull-out rollers.
3) Control the center blower and side blower.
Sheet separator
Operation Edition - 70
Control the center blower and side blower volume so that the top 5 to 6
sheets of paper are separated and so that the top sheet lightly contacts the
sheet separator.