Chapter 1 Operation Procedures
Insert the tail edge of the plate into the clamp and
tum the clamp bolt until the red mark faces you to
fix it.
Push the plate hold-down button to release the water
form roller from the plate surface.
Push the crawl button so that the line (1) on the plate
cylinder gear cover is between the 2 lines (2) on the
plate cylinder.
Tum the quick tension bolt in the direction of the
arrow to tension the plate.
A
CAUTION
Remove the wrench from the quick tension bolt before pushing the crawl button,
when the plate cannot be tensioned properly at the plate cylinder gap position. Failure
to follow this instruction may result in an injury.
Operation Edition - 15