Ryobi 3302H Operation Manual page 107

I!::::::==D=o=o
~
~ocmmo
(1.57" or more)
2mmormore
(0.08" or more)
Chapter 1 Operation Procedures
Push the plate load button. The leading edge clamp
will close. Close the safety cover and push the button
again. The press will start to mount the plate
automatically.
After that, the buzzer sounds.
(Reference) Set the plate pressure adjustment scale
on the plate thickness to be used.
(Note) 1. Put the plate on a flat surface after bending
the plate tail edge. At this time, if the top
of the plate tail edge is 40 mm (1.57") or
more, the plate tail edge may not be able
to be mounted correctly.
Roll the plate in the reverse direction so
that the plate curl will be fixed.
2. When reusing a plate with the plate tail
edge waved 2 mm (0.08") or more, the
plate tail edge may not be able to be
inserted correctly.
When storing used plates, please put the
used plate on a flat surface so that the plate
will not become wavy.
Operation Edition- 21