Ryobi 3302H Operation Manual page 123

Chapter 1 Operation Procedures
3) Set the retainers.
A
CAUTION
Stop the press before setting. Failure to follow this instruction may result in an
injury.
Incorrect
There are 2 different retainers. The retainer (A) has
a square edge. The retainer (B) has a rounded edge.
Mount the retainer (A) on the pull-out roller shaft.
(A)
(B)
Mount the retainer (B) on the shaft over the feeder
board. There are 2 types of retainers, one for thin
paper and the other for thick paper. When using
paper less than 0.1 mm (0.004") thick, use the thin
retainer.
The retainers (1) should always be set on both outer
board tapes.
(Note) Do not push the retainer down strongly.
Operation Edition - 37