Crawl Operation Panel - Ryobi 3302H Operation Manual

2-4 Crawl Operation Panel
8B
~c
A.
~
Emergency stop button
When pushing this button, the press will stop and
the button will lock. In this condition, the press
cannot be run and also crawl operation cannot be
done. When turning the button in the direction of
the arrow, the lock will be released and the press can
be run and crawled.
B.
IT§]
Reverse crawl button
WARNING
Never touch the rotating parts when doing the
crawl operation. Failure to follow this
instruction may result in a serious injury.
When pushing this button with the crawl ON/OFF
button on this panel locked, the press will crawl in
the reverse direction.
There are 2 different kinds of crawl operation speed
(1 m/min. and 3 m/min.).
( ..,. Safety Operation Edition - 19)
C. ~Crawl ON/OFF button
When pushing this button, the press will stop and
the button will lock. In this condition, the press
cannot be run, but the crawl operation can be done.
When turning the button in the direction of the arrow,
the lock will be released and the press can be run.
D.
[§]
Forward crawl button
WARNING
Never touch the rotating parts when doing the
crawl operation. Failure to follow this
instruction may result in a serious injury.
When pushing this button with the crawl ON/OFF
button on this panel locked, the press will crawl in
the forward direction.
There are 2 different kinds of crawl operation speed
(1 m/min. and 3 m/min.).
(..,. Safety Operation Edition- 19)
Chapter 2 Names and Functions
A
WARNING
. . Never touch the rotating parts when doing the
crawl operation. Failure to follow this instruction
may result in a serious injury.
• The crawl ON/OFF buttons and crawl buttons are
located at the 2 places marked 1 and 2.
The crawl operation is possible when the crawl ON/
OFF button on each panel is pushed. When pushing
the crawl ON/OFF button, the lamp will light.
a. While lighted ....... The crawl operation can be done.
b. While flickering .. The crawl operation cannot be
done.
(
2 crawl ON/OFF buttons are )
pushed or a safety device is
actuated.
c. While OFF .......... The crawl operation cannot be
done.
• Plate cylinder predetermined position stop
function
With the drive lamp lighted, when pushing the
(forward/reverse) crawl button 1 or 2 shown in the
illustration, the press crawls and stops automatically
at the position where mounting/removing the plate can
be done easily.
Crawl button Plate cylinder stop position
[§]
Position where it is easy to mount a
1
plate on the first unit
IT§]
Position where it is easy to remove a
plate on the first unit
[§]
Position where it is easy to mount a
plate on the second unit
2
Position where it is easy to remove a
IT§]
plate on the second unit
Introduction Edition - 19