Ryobi 3302H Operation Manual page 111

I!::::::=D=o=~
Chapter 1 Operation Procedures
Push the plate load button. The leading edge clamp
will close. Close the safety cover and push the button
again. The press will start to mount the plate
automatically.
After that, the buzzer sounds.
«NOTICE»
When the paper master is mounted without
the tail edge clamped, do not crawl the press
in the reverse direction because the paper
master will roll up in the rollers.
(Reference) Set the plate pressure adjustment scale
on the plate thickness to be used.
(Note) Put the plate on a flat surface after bending
the plate tail edge. At this time, if the top of
the plate tail edge is 40 mm (1.57") or more,
the plate tail edge may not be able to be
mounted correctly.
Roll the plate in the reverse direction so that
the plate curl will be fixed.
(Note) When the paper master is mounted without the tail edge clamped, the registration accuracy
is reduced depending on the paper master stretch during continuous printing or the paper
master mounting accuracy.
So only single color printing using 1 unit is recommended.
Operation Edition - 25