Setting The Paper Feed Section - Ryobi 3302H Operation Manual

Chapter 1 Operation Procedures
7. Setting the Paper Feed Section
1) Pile the paper on the paper feed table.
A
CAUTION
Stop the press before piling. Failure to follow this instruction may result in an
injury.
Put the paper pile board (2) on the supports
(1)
of
the paper feed table.
«NOTICE»
If the press runs with the supports removed, the
press may be damaged.
When running the press, the supports must be
mounted on the paper feed table.
(Reference) There are 4 different size paper pile
boards included with the press. Use the
board that corresponds to the sheets
of paper to be printed.
Paper pile board
0-5mm
(0-0.2")
A multi-size paper pile board that can hold paper
from 170 x 210 mm (6.69 x 8.27") to 340 x
450 mm (13.39 x 17.72") in size is available as an
optional accessory.
Set the movable plate (1) to match the paper size
being fed.
Operation Edition - 27