Ryobi 3302H Operation Manual page 197

Chapter 4 Replacing the_ Supplies
When removing the blanket, reverse the mounting procedures.
Mounting procedures - - - - - - - - - - - - - - - - - - - - - - - - - - - - .
1. Attach the under blanket on the
back of the blanket.
I
8
As the mounting position is
indicated on the back of the
blanket, fix the under blanket on
that position using the double
sided tape that comes with the
under blanket.
8
~~
~,.,1
L
~
~
/ = - - =~
4. Mount the blanket tail edge in
the blanket cylinder clamp
holder on the tail edge by using
the 4 mm (0.16") Allen wrench.
II
7. Finally turn the blanket tension
bolt the 114 to 112 turn further
for the final tensioning.
2. Loosen the tension knob and
mount the blanket leading edge
on the blanket cylinder clamp
holders (1) on the leading edge.
(Reference)
The fixing side of the blanket
and under blanket with the
tape is the leading edge.
5. Turn the tension knob to tension
the blanket.
I II
l=vJ
n n
jJl
1' 1 ' \
/
/
~
~
3. Continuously pushing the for-
ward crawl button, while pulling
the blanket and under blanket to
fit it on the blanket cylinder.
11
6. Tighten the blanket tension bolts
(Leading edge, Tail edge).
Feed about the 10 sheets of paper
to fit the blanket to the cylinder
and then tension the blanket
again. Repeat this procedure 2 or
3 times.
Maintenance Edition - 39