Adjustment And Maintenance That Should Be Done By The Operator; Never Replace Any Parts Other Than The Consumables - Ryobi 3302H Operation Manual

Chapter 5 Precautions When Doing Maintenance
A
CAUTION
Adjustment and maintenance that should be done by the operator!
The adjustment of the ink and water roller pressure, adjustment of the feeder section, checking the air pump,
checking the dampening solution cooling/circulation device, and lubrication following the lubrication chart are the
adjustments and maintenance listed in the operation manual that should be done by the operator.
All other adjustments and maintenance should be done by the service technician who has special knowledge and
technical expertise through training, so consult the dealer who you purchased the press from.
Turn off the power before cleaning the
static eliminator!
Turn off the power before cleaning the static eliminator
electrode.
Failure to follow this instruction may result in an electric
shock.
Never replace any parts other than the
consumables!
Never replace any parts other than the consumables
shown in the maintenance edition "Chapter 4
Replacing the Supplies" in this manual.
The replacement of all other parts should be done by
a service. technician who has special knowledge and
technical expertise through training, so consult the
dealer who you purchased the press from.
Failure to follow this instruction may result in an injury.
Safety Operation Edition - 17