Chapter 2 Periodic Inspection; Checking The Roller Pressure - Ryobi 3302H Operation Manual

Periodic Inspection
«NOTICE»
Check each section periodically to keep the press in top operating condition.
1. Checking the Roller Pressure
I
The roller pressure has a great influence on the printing results and ink roller cleaning. Check the pressure at a mini-
mum of once every 3 months.
1) Checking and adjustment of the ink form roller pressure
A
WARNING
1. Never touch the rotating parts when doing the crawl operation.
2. Close the cover opened after finishing the inspection.
Failure to follow these instructions may result in a serious injury.
Checking the roller pressure - - - - - - - - - - - - - - - - - - - - - - - - - - - ,
CYCLE
SET
UNIT
Maintenance Edition - 1 0
Push the cycle set button on the delivery section auxiliary switch
panel and set it to the cycle "9".
(Note) When setting it on the cycle "9", the press can be stopped
with the ink form rollers and water form roller in contact
with the plate surface. When checking and adjusting the
form roller pressure, the cycle should be set on "9". After
completing the adjustment, the cycle should be returned to
"0".
Push the unit selection button of the unit on which the roller
pressure adjustment will be done.
(Note) The checking and adjustment should be done on each unit.
Sign Nip width (mm) (inch) Sign Nip width (mm) (inch)
A
3.0 (0.118")
D 3.5 (0.138")
B
3.0 (0.118") E 3.5 (0.138")
c
3.0 (0.118")
F
3.5 (0.138")