Profibus Machine Control Panel On The Hmi; Configuration Of The Properties Of The Network Interface For Profibus - Siemens SINUMERIK 840D sl Commissioning Manual

13.11

PROFIBUS machine control panel on the HMI

Configuration of the PROFIBUS machine control panel
The following is essential for a PROFIBUS machine control panel on the HMI:
● Configuration of the properties of the network interface for PROFIBUS
● Supplementation of the machine control panel and hand wheel in HW Config
● Modification of the machine control panel in OP100
13.11.1

Configuration of the properties of the network interface for PROFIBUS

Introduction
In the STEP7 project, you configure the network interfaces PROFIBUS DP, via which you
want to reach the machine control panel:
Steps for PROFIBUS DP
1. You used the left mouse button to select NCU 720.1 and while holding down the mouse
2. After you release the mouse button, configure the properties of PROFIBUS DP interface
Figure 13-32 Properties of PROFIBUS DP
3. Click the following menu items one after the other:
4. Select the transmission rate "12 Mbps" for the "DP" profile (see figure below).
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
button you dragged it to the "Station design" station window.
for socket X126 (machine control panel) in the dialog box (see figure below).
– the "New..." button,
– the "Network settings" tab in the "Properties new subnet PROFIBUS Subnet" dialog
box.
13.11 PROFIBUS machine control panel on the HMI
Tips
259