Integrating Pg/Pc Into Netpro - Siemens SINUMERIK 840D sl Commissioning Manual

13.4.1

Integrating PG/PC into NetPro

Introduction
To enable the communication between PG/PC <-> HMI via Ethernet, the PC/PG is to be
included in the network configuration of the system.
To integrate the PG/PC, proceed from the following starting situation in the
SIMATIC Manager.
You are in the HW config in the created project "PLC-Erst-IBN 840D sl" (see figure below).
Figure 13-7
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
HW config project "PLC-Erst-IBN 840D sl"
13.4 Integrating PG/PC into the network (NetPro)
Tips
223