Insert Ncu 7X0 In Hw Config - Siemens SINUMERIK 840D sl Commissioning Manual

7.1.3

Insert NCU 7x0 in HW config

Introduction
The user interface of "HW config" mostly displays (see the following figure):
● Station window:
● Hardware catalog
Use the operator input sequence steps described below to insert an NCU 720.1 as example.
Operating steps
1. Select "View > Catalog".
2. Search for the module in the catalog under "SIMATIC 300 > SINUMERIK > 840D sl >
Figure 7-3
3. Select NCU 720.1 with the left mouse button, hold the mouse button down and drag to
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
The station window is split. The upper part displays the structure of the station
graphically, and the lower part provides a detailed view of the selected module.
In this catalog, the NCU 7X0 that you need for configuring the hardware is also included.
NCU 720.1" (see following figure).
NCU 720.1 in the catalog
the "Station design" station window.
After you release the mouse button, configure in the dialog box the interface properties of
processor CP 840D sl located on NCU 720.1 (see next chapter).
PLC commissioning
7.1 Creating a SIMATIC S7 project
43