Siemens SINUMERIK 840D sl Commissioning Manual page 249

Figure 13-29 "Topology" menu after "OK"
IBN CNC: NCK, PLC, drive
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
The actual state is displayed in the topology.
If you select the component with the cursor keys, the HMI informs you in the bottom
area of the topology table, which components have been assigned to which
component.
Note
A non-assigned component must be commissioned with the drive wizard.
You can start the drive wizard from the "Topology" menu with the following operating
sequences:
1. Press the <RECALL> key.
2. Press "Drive".
13.7 Extending/checking the topology
Tips
249