Siemens SINUMERIK 840D sl Commissioning Manual page 90

Commissioning SINAMICS drives
8.5 Commissioning using a drive wizard
6. Select "Enter motor data" and the motor type.
7. Press "Next >".
Figure 8-42
8. You can select brake control in the dialog "Configuration motor holding brake".
9. Press "Next >".
Figure 8-43
10. Use the "Cursor Up/Cursor Down" keys to select the parameters that need to be changed
from the list of motor data.
11. Enter the motor data.
12. Press "Next >". If you have selected "Replacement circuit diagrams" and you select "Next
>", then you get to the following dialog:
90
Menu "Drives > Configuration" "Motor holding brake" (Next 2)
If a connected brake is detected during the unit configuration, the system will
automatically activate the brake control and will by default display "Brake control
according to procedural control" here.
Menu "Drives > Configuration" "Motor data 2" (Next 3)
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
IBN CNC: NCK, PLC, drive