Siemens SINUMERIK 840D sl Commissioning Manual page 148

NCK start-up
10.5 Parameterize axis data
2. SD: JOG_REV_IS_ACTIVE (revolutional feedrate in JOG mode) = 1
The entered value may not exceed the max. permissible axis velocity.
NOTICE
Depending on MD30300 IS_ROT_AX[n], the velocities have to be entered in mm/min,
inch/min, or rpm.
If the velocities are changed, MD36200 AX_VELO_LIMIT[n] (threshold value for velocity
monitoring) must be adapted accordingly.
Machine data
Table 10-23 Velocities: Machine data
Number Identifier
axis-spec. ($MA_ ... )
30300 IS_ROT_AX[n]
32000 MAX_AX_VELO[n]
32010 JOG_VELO_RAPID[n]
32020 JOG_VELO[n]
32040 JOG_REV_VELO_RAPID[n]
32050 JOG_REV_VELO[n]
32060 POS_AX_VELO[n]
32250 RATED_OUTVAL
32260 RATED_VELO[n]
148
JOG velocity = SD41110 JOG_SET_VELO (JOG velocity for G94)
– Rotary axes:
JOG velocity = SD41130 JOG_ROT_AX_SET_VELO (JOG velocity for rotary axes)
– JOG velocity = SD41120 JOG_REV_SET_VELO (JOG velocity for G95)
Name / remarks
Rotary axis
Maximum axis velocity
Rapid traverse in JOG mode
JOG axis velocity
Revolutions feedrate in JOG mode with rapid
traverse override
Revolutional feedrate in JOG mode
Initial setting for positioning axis velocity
Rated output voltage
Rated motor speed
Commissioning Manual, 07/2007, 6FC5397-2AP10-3BA0
Reference
G2
P2
IBN CNC: NCK, PLC, drive