Table of Contents
Advertisement
Shipment and Storage
Siemens Vacuum Recloser 3AD
14
Note:
Damage to property
Control cubicle can tilt over
while
lifting and
may
crash against the
wall of the box.
For temporary
storage put the control cubicle on a wooden base
(for example the partitions of
the
carrier
box)
so that the connectors
will
not be damaged.
Look for a
safe
stand!
5) Take out
the
additional components located
underneath the switch
unit
(see
Fig
.
8).
6) Lift the
control
cubicle out of
its packaging
by
using
the
2
upper lifting eyes
(see
Fig. 9).
Fig
.
8
Re
moving
additiona
l
component
s
Fig.9
Lifting out off control cub icle
Note:
Damage
to property
The control cubicle, Fig.
10,
must not be placed on the connections
for the control and
sensor cable.
If the batteries are installed
,
do
not lay the control cubicle on any side!
For interim storage at the assembly location
,
place the switch unit
Fig
.
11 on a suitable ground
.
The feet are designed to support the
switch unit. Avoid damage to the position indicator and lock-out
handle, e. g. caused by an uneven floor surface!
Any damage to the surface coating must be repaired with a touch
up pen (color RAL 7035) before commissioning
.
This is essential to
ensure sufficient corrosion protection
.
9229
0040 176 OF
2017-12-18
Advertisement
Chapters
Table of Contents
