Intel Stratix 10 MX HBM2 IP User Manual page 8

Table 1. Summary of Per-channel Signals
Signal Name
Data
Column command/address
Row command/address
DBI
DM_CB
PAR
DERR
Strobes
Clock
CKE
AERR
The following table lists the HBM2 signals that are common to all Pseudo Channels in
each HBM2 interface. The HBM2 controller interfaces with the following signals; these
signals are not available at the AXI4 user interface.
Table 2. Summary of Global HBM2 Signals
Signal Name
Reset
TEMP
Cattrip
The Intel Stratix 10 MX HBM2 IP supports only the Pseudo Channel mode of the HBM2
specification. Pseudo Channel mode includes the following features:
• Pseudo Channel mode divides a single HBM2 channel into two individual
subchannels of 64 bit I/O.
• Both Pseudo Channels share the channel's row and column command bus, CK, and
CKE inputs, but decode and execute commands individually.
• Pseudo Channel mode requires a burst length of 4.
• Address BA4 directs commands to either Pseudo Channel 0 (BA4 = 0) or Pseudo
Channel 1 (BA4 = 1). The HBM2 controller handles the addressing requirements of
the Pseudo Channels.
• Power-down and self-refresh are common to both Pseudo Channels, due to a
shared CKE pin. Both Pseudo Channels also share the channel's mode registers.
Each Intel Stratix 10 MX HBM2 interface supports a maximum of eight HBM2 channels.
Each HBM2 channel has two AXI4 interfaces, one per Pseudo Channel. The following
figure shows the flow of data from user logic to the HBM2 DRAM through the UIBSS,
while selecting HBM2 channels 0 and 7.
® ®
Intel Stratix 10 MX HBM2 IP User Guide
8
Signal Width
128
8
6
16
16
4
4
16
2
1
1
Signal Width
1
3
1
2 Intel Stratix 10 MX HBM2 Architecture
UG-20031 | December 2017
Notes
128 bit bidirectional DQ per channel
8-bit wide column address bits
6-bit wide row address bits
1 DBI per 8 DQs
1 DM per 8 DQs. You can use these
pins for DM or ECC, but not both.
1 parity bit per 32 DQs
1 data error bit per 32 DQs
Separate strobes for read and write
strobes. One differential pair per 32
DQs for read and write.
Clocks address and command signals
Clock enable
Address error
Notes
Reset input
Temperature output from HBM2.
Catastrophic temperature sensor.