Ricoh BRG-P1w Field Service Manual page 358

Paper Type Mismatch
The type of paper in the selected tray does not match the size of the paper selected for the job
Follow the procedure below:
• Check the paper cassette and make sure that the paper type matches the settings selected in
the printer driver.
• Press the [Form Feed] key, select a paper tray containing paper of the specified type, and
then print.
• Cancel the print job.
Paper Size and Type Mismatch
The type and size of paper in the selected tray does not match the type and size of the paper
selected for the job, or the type and size of the paper in any of the paper trays does not match the
type and size of the paper selected for the job when using Auto Tray Select.
Follow the procedure below:
• Check the paper cassette and make sure that the paper size and type matches the settings
selected in the printer driver.
• Press the [Form Feed] key, select a paper tray containing paper of the specified size and type,
and then print.
• Cancel the print job.
Print Cartridge(s) Not Detected/Cover Open
• The right front cover is open. Close the right front cover.
• The print cartridges are not installed or are installed incorrectly. Install the print cartridges
correctly.
Printer Error
An error has occurred in the printer. An error code ("SC###-"##") appears at the end of the
message.
1. Cycle the printer off/on.
2. If the printer has just been moved from a cold location to a warm room, wait at least 1 hour
and try again.
Replace Ink Collector Unit (Consumables)
The ink collector is full. Printing cannot continue. The ink collector must be replaced.
Unit Not Detected / Cover Open
The duplex unit is not mounted correctly and/or the duplex unit cover is open.
Mount the duplex unit correctly and close the duplex unit cover.
Make sure the latches are lock at both ends. They should lock automatically.
Error Codes
111