Ricoh BRG-P1w Field Service Manual page 204

6. Troubleshooting
No.
Temp. alert
14
Please wait...
15 Right Int. Unit almost full
Indepdnt.ink set
--or--
Indepdnt.ink set / Replace Ink
16 Crtg
--or--
Indepdnt.ink set / Press # to
continue
Maint. failed
17
Press # to exit
18 Prepare new Ink Collector Unit
4. Operator Calls
No.
Open Front Cover / Replace
19
Ink Crtg
Open Front Cover / Reset
20
Cartridge
202
Message
Machine temperature was abnormal at power on. Wait for
the "Ready" message.
Replace the internal unit (right ink sump).
An ink tank cartridge unapproved for use with this machine
has been installed. Use of ink cartridges not approved for
use with this machine, or attempting to re-fill depleted ink
cartridges, will diminish print quality. Always use new Ricoh
ink cartridges specifically designed for use with these
machines.
Print head cleaning, print head flushing, or another
operation failed. The machine can be released from the
error by one of the following conditions.
• When the next job request is detected
• After the [#] key is pressed
The ink collector unit is almost full.
Make sure you have a new ink collector on hand.
If a print cartridge starts running out of ink when the ink
collector unit is almost full, the alert indicator will flash and a
message informing you of the cartridge's low ink level will
appear on the display. To prevent job delay due to a full ink
collector unit, always have a new ink collector unit ready.
Message
Ink cartridge is empty. Replace the empty cartridge with a
new one.
Ink cartridge is not installed. Or, the ink cartridge is installed
but not set correctly. Set the ink cartridge correctly.
Action
Action