Ricoh BRG-P1w Field Service Manual page 322

No. Message
06 Setting Change...
Panel Locked
07
Cannot use
08 Maintenance in Process...
09 Page Drying...
Cleaning Feed Belt...Wait
10
2min
11 Shutting down...
2. Diagnostic Errors
No. Message
Hardware Problem: Ethernet
12
Board
3. Warning Errors
No. Message
13 Low Ink
Temp. alert
14
Please wait...
15 Right Int. Unit almost full
Print settings are being updated. Wait a few moments.
You have pressed a locked key on the operation panel, so
release the lock.
Print head cleaning or flushing is in progress. Wait for print
head maintenance to finish.
Being dried.
Charge leakage is being removed.
This appears while the machine shuts down.
Ethernet error occurred. Disconnect all connected cables,
and then cycle the machine off/on. If this message is
displayed again, call for service.
Ink cartridge is almost empty. Note the color of the ink
cartridge where ink supply is low, and then procure and
new cartridge of the same color.
Machine temperature was abnormal at power on. Wait for
the "Ready" message.
Replace the internal unit (right ink sump).
Error Codes
Action
Action
Action
75