• Replace inverter guide.
Action 2
• Replace trailing edge sensor.
• Replace CTL board.
Jam 6
Paper Feed Jam (Bypass Tray)
Paper Misfeed
Message
Remove Bypass Tray and reset the paper. If there is any paper that is jammed remove
it.
• Paper slippage
Cause
• Paper not loaded correctly
The registration sensor did not detect the leading edge of the paper fed from the
Details
bypass tray within the prescribed time .
• Remove bypass tray
Action 1
• Load paper correctly.
• Check inside the paper for jammed paper or paper scraps.
• Clean transport belt.
• Replace Registration Sensors 1, 2.
Action 2
• Replace Multi Bypass Tray.
• Replace the printer.
Jam 7
Transport Jam (Tray 2: PFU)
Paper Misfeeed
Message
Press the Form Feed button.
Cause
Paper longer than the paper selected in printer driver was loaded.
When paper was fed from Tray 2 the paper fed but the paper failed to leave the
Details
trailing edge sensor within the prescribed time.
• Check the size of the paper loaded in the PFU
Action 1
• Make sure that the size of the paper selected in the printer driver matches the
size of the paper loaded in the tray.
Error Codes
227