Ricoh BRG-P1w Field Service Manual page 324

No. Message
Cannot use High Temp./
25
Power Off On
Cannot use Low Temp./Power
26
Off On
Ink depleted / Used Ink
27
Crtrdge
Used Ink Collect Unit is set/
28
Replace Ink Collector Unit
29 Reset Bypass Tray correctly
Load Paper:Tray 1
--or--
Load Paper:Tray #/ or Form
30 Feed
--or--
Load Ppr.:Bypass / or Form
Feed
Change Setting Tray # /
31
(paper size) (paper type)
Machine temperature is high and has exceeded the high
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
Machine temperature is low and has fallen below the low
temperature range for normal operation. Re-locate the
machine to a location within the temperature range and wait
for the machine to acquire room temperature.
A used print cartridge has been installed. Install a new print
cartridge.
A used ink collector unit has been installed. Install a new ink
collector unit.
Multi bypass tray unit is not set correctly. Make sure that the
multi bypass tray is set correctly.
Paper has run out in the selected tray. Load paper in the
selected tray. Or, press [Form Feed] and select another tray
holding paper for printing. Press [Job Reset] to delete any
data remaining from the previous job. The tray numbers
depend on the machine model.
• The trays are designated Tray 1, 2 or Bypass.
The type and/or size of paper in the selected tray do not
match the type and/or size of the paper selected for the job.
Replace the paper in the tray with paper of the size/type
selected for the job, and then change the paper size/type
on the operation panel. Or, press [Form Feed] and select
another tray holding paper of the size/type selected for
printing. Press [Job Reset] to delete any data remaining from
the previous job. The tray numbers depend on the machine
model.
• The trays are designated Tray 1, 2 or Bypass.
Error Codes
Action
77