Create S-Vlans For Shdsl Cards (If Required) - Ericsson EDA 2530 Commissioning Instructions

e.
f.
g.
7.7.2

Create S-VLANs for SHDSL Cards (If required)

The template file previously loaded creates the VLAN data for the ADSL slot 2 card
only, additional S-VLANs must be created for the SHDSL cards in the
"DATA_INBAND" name. For each SHDSL card there must be a "DATA_INBAND"
entry, e.g. for SHDSL slot 20 it is "intLag//1/20", for SHDSL slot 21 it is
"intLag//1/21".
For each SHDSL card create a new "intLag//.." entry for the SHDSL slot(s), as
detailed in the following steps.
a.
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
In the "Command" column, against the new "intLag//1/.." entries just
created, double click on the empty field and select the "addPort" option
from the drop-down list. All new entries in the "Command" column will now
be set to "addPort".
Select "Apply All" from the bottom LHS of the screen. The rows will turn
Green and under the "Result" column the field should display "OK".
Select "Read Network" near the top of the screen, this will confirm the
configuration, if there are any incorrect entries they will be highlighted at
this point.
Double left-click on the "intLag//1/2" entry in "User Port Interface Name"
column.
EDA 2530 Commissioning Procedure for Cable and Wireless Access
© Ericsson AB 2010
Commercial in confidence
83 (200)