Configure Shdsl Stack Profiles - Ericsson EDA 2530 Commissioning Instructions

Profile Name
1
Ultra-Short
Extra-Short
Short
Medium
Long
Profile Name
1
Ultra-Short
Extra-Short
Short
Medium
Long
The above tables show a typical example of SHDSL Line Profiles. Actual required
SHDSL Line profiles should be supplied by the Customer.
7.16
Note: This section ONLY applies to SHDSL Profiles.
Configure the EDA2530 SHDSL Stack Profiles via the LCT.
a.
b.
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
Wire Interface
2 Wire
2 Wire
2 Wire
2 Wire
2 Wire
2 Wire
Downst Downst
CurrCond WorstCase
5
5
5
5
5
5

Configure SHDSL Stack Profiles

From the LCT main screen select the path Configuration > SHDSL
Profiles and Setup. Click Stack Profiles button. The "SHDSL Stack
Profiles" screen will be displayed:-
Note: If there is an SHDSL card already configured in the EDA2530 then
click the Read Network button to view and check the SHDSL Stack
Profiles. If the profiles are correct this sub-section is not required. If the
profiles are not correct then perform the rest of this sub-section.
Select File > Open, then navigate to the "SHDSL Stack Profiles.psp"
template file. Then select Open to load this profiles file.
EDA 2530 Commissioning Procedure for Cable and Wireless Access
Min Line Rate bps
192K
192K
768K
768K
512K
256K
Upst
CurrCond
5 5
5 5
5 5
5 5
5 5
5 5
© Ericsson AB 2010
Commercial in confidence
Max Line Rate bps
5696K
5696K
3072K
2752K
2048K
1024K
Upst Used SNR
WorstCase Target
Margins
5 CurrCondDown
5 CurrCondDown
5 CurrCondDown
5 CurrCondDown
5 CurrCondDown
5 CurrCondDown
118 (200)