Configure Adsl Profiles - Ericsson EDA 2530 Commissioning Instructions

7.14

Configure ADSL Profiles

Note: This section ONLY applies to ADSL Profiles.
a.
b.
c.
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
From the main LCT screen, select the path Configuration > xDSL
Profiles. The "Line Profile Management" window will open.
Select "File" then "Open", then navigate to the relevant folder and select
the template file "xDSL Profile Management - xDSL Line Profile.ap".
Select "Open", then the following screen will be displayed which will default
to the "Channel" tab:-
In the "Ne Name" column the template will load the default OOB IP
address of 150.150.150.4, the Node being commissioned is likely to have a
different one allocated to it. The Out Of Band IP Address is determined by
the DLE ID, refer to Section 5.5. Change the address (if necessary) in this
column for all entries, as follows:-
st
Change the 1 entry in this column to the correct IP address, select the 1
entry, then left-click the 1
to highlight all entries. Right click & select "Replicate cell", all entries in the
"Ne Name" column will now be set to the required OOB IP Address.
EDA 2530 Commissioning Procedure for Cable and Wireless Access
st
entry & drag down to the bottom of the column
© Ericsson AB 2010
Commercial in confidence
st
114 (200)