Initial Configuration; Ip Address Configuration Of Pc Used As Lct - Ericsson EDA 2530 Commissioning Instructions

5

Initial Configuration

Prior to testing, the Common Part IP unit requires configuring in accordance with the
parameters assigned to the system.
This section details the process to configure IP addresses/parameters needed for
management of the equipment from LCT and from the appropriate workstation for
network management.
For identification of the IP addresses/parameters assigned to the system, refer to
the Network planning guide.
5.1

IP Address Configuration Of PC Used As LCT

Before connecting the laptop to the Common Part IP unit, the laptop must be
configured to be in the same IP Network Address range as the Out of Band
Management IP Address of the EDA 2530.
Note:
Vista OS use step c, all other steps are common to Windows 2000/XP/Vista OS.
a.
b.
c.
d.
e.
f.
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
For Windows 2000 OS use step a, for Windows XP use step b, and for
For Windows 2000, left click on the Start button, then select Settings >
Control Panel.
Double left click on the Network and Dial-up Connections icon.
For Windows XP, left click on the Start button, then select Control Panel.
Double left click on the Network Connections icon.
For Windows Vista, left click on the Start button, then select Network >
Network and Sharing Center > Manage network connections.
Right click on Local Area Connection icon and then click Properties.
In the 'LAN Properties' window, use the scrollbar to move down the list.
For Windows 2000/XP select the 'Internet Protocol (TCP/IP) entry, but for
Windows Vista select the 'Internet Protocol Version 4 (TCP/IPv4) option,
then left click on the 'Properties' button.
EDA 2530 Commissioning Procedure for Cable and Wireless Access
© Ericsson AB 2010
Commercial in confidence
47 (200)