Checking And Changing Q Parameters - HEIDENHAIN TNC 620 User Manual
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (571 pages)
Table of Contents
Advertisement
6
Checking and changing Q parameters
Procedure
You can check Q parameters in all operating modes, and also edit
them.
If you are in a program run, interrupt it if required (e.g. by
pressing the NC stop key and the INTERNAL STOP soft key) or
stop the test run
To call the Q parameter functions, press the
Q INFO soft key or the Q key
The control lists all of the parameters and their
corresponding current values.
Use the arrow keys or the GOTO key to select
the desired parameter.
If you would like to change the value, press the
EDIT CURRENT FIELD soft key. Enter a new value
and confirm with the ENT key
To leave the value unchanged, press the
PRESENT VALUE soft key or close the dialog with
the END key
All of the parameters with displayed comments are used
by the control within cycles or as transfer parameters.
If you want to check or edit local, global or string
parameters, press the SHOW PARAMETERS Q QL QR QS
soft key. The control then displays the specific
parameter type. The functions previously described also
apply.
258
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Testing and running | Program run
Advertisement
Table of Contents
