The Control In A Network - HEIDENHAIN TNC 620 User Manual

Fundamentals | File management
Preventing incomplete NC programs
The control checks all NC programs for completeness before
machining. The control displays a warning if the END PGM NC block
is missing.
When you start the incomplete NC program in Program run, single
block or Program run, full sequence operating mode, the control
aborts with an error message.
Proceed as follows to edit the NC program:
Select the NC program in Programming operating mode
The control opens the NC program and automatically adds the
END PGM NC block.
Check the NC program, and complete it if necessary
Press the SAVE AS soft key
The control saves the NC program with the END
PGM NC block that has been added.

The control in a network

Protect your data and your control by running your
machines in a secure network.
Use the Ethernet card to connect the control to the
network.
Further information:
The control logs any error messages that occur during
network operation.
If the control is connected to a network, the left directory window
displays additional drives. All the functions described above
(selecting a drive, copying files, etc.) also apply to network drives,
provided that you have been granted the corresponding rights.
The control can also run NC programs directly from a
network drive. The external drive does not provide write
protection, however. This may lead to problems caused
by data transfer or by a change to the NC program
during machining.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
"Ethernet interface ", Page 392
3
83