Changing A Program Step - HEIDENHAIN ND 1200 - V2.16 Operating Instructions Manual

Changing a program step

Program steps can be edited to change:
Program properties
Settings
Tolerances
To change program steps:
U Use the ARROW CURSOR keys to highlight a step. Expand the step
if necessary.
U Press the ENTER key to cycle through the available alternatives and
select a new value for the highlighted the step.
U Press the FINISH key to change the step.
U Press the FINISH key again to leave the edit mode and return to the
programs screen.
Example of changing ND 1200 settings
In this example, ND 1200 settings will be edited to change the unit of
measure from mm to inches:
To change ND 1200 settings:
U Use the ARROW CURSOR keys to highlight the Settings step.
U Press the ENTER key to expand the Settings step.
U Use the ARROW CURSOR keys to highlight the Units step.
U Press the ENTER key to change the Units step value from mm to
inch.
U Press the FINISH key to save to change and return to the Programs
screen.
The Settings step is highlighted and
expanded
64
The Units step is highlighted The ENTER key is pressed to change
from mm to inch units
1 Operation